Kitchen

Kitchen Countertop: Do not cut on or place hot items directly on the counter. Always use a cutting board or heatproof pad/surface cover. During your tenancy, you will be held accountable for damages, scratches, burns etc. 

 

Kitchen sink: Leaks are to be reported immediately, and water main turned off.

 

Garbage Grinder in kitchen sink: Only soft peels and vegetables are to be inserted. No pits, paper, plastic, nuts, or other hard items are to be inserted.

Washing machines & combination washer/dryer: Choose preferred settings on the dial (type of wash, colored/white washes etc.) and corresponding temperature dial, if applicable, and push the power or start button. Most washing machines have listed settings with the appropriate temperature and time frame. It is a good idea to drain the filter compartment from time to time, generally located in the bottom front of the washing machine.

 

Always clean the lint trap located in the drum of the dryer to ensure maximum efficiency. Failure to do so will reduce the drying heat and can even cause a fire.

 

Hot Water Heater: Most properties in Israel have solar heating systems for their hot water supply. This is often supplemented by an electric hot water boiler which can either be activated manually or set for specific times. Your consultant will assist you with the time settings.

The boiler should not be on for more than 2-3 hours and should only be used in the colder months, as the solar heaters are effective and cost saving. Some homes have gas hot water heating systems which are centrally controlled by the building management.

 

Air Condition Units for Cooling and Heating: A/C units in Israel serve both as cooling and heating systems. Every 6 months, you are required to clean the filters of individual units in order to ensure effective operation. In the winter months, it is recommended to keep the room temperature at 25C. The units must be switched off when leaving the house. The filters of a central air condition system are treated by the relevant company. 

 

Fuse Board/Breaker box: This is usually located at the entrance of the residence either inside the home or outside the front door.

 

Switches can trip for a number of reasons:

    • Overloaded circuit – too many electrical appliances used simultaneously
    • A faulty appliance
    • Faulty connections on appliance leads
    • Water penetration

The switch may have tripped for one of the above reasons, and in order to find out which appliance or area is causing the problem, you should flick all the switches down and then flick up the switches one by one. Once you switch on the breaker that causes the circuit to trip, you will have located the root cause and should unplug that breaker. In doing so, the issue will be partially resolved. An electrician or the landlord should be involved to solve the issue completely.

 

Smoke Detectors: are not installed in all properties, but if so they are usually located in hallways, and bedroom areas. If there is a continual beep, the battery needs to be replaced, and this can be bought at any DIY or grocery store. In the event that the detector continues to beep despite having changed the battery, contact your landlord.

Ocean Relocation is happy to provide additional information. To set an appointment to speak, please contact:

Daniel Drenger, Adv., GMS
Client Services & Partner Relations Executive

Sasha Avrahamov
Relocation Consultant

The item has been added to your order! 🙂